Threepointsix
JK Enthusiast
Nice fancy red carpet you have there
ya man, I had to put something down on that cold concrete floor. It is funny, though. Sort of like the 'royal carpet' for my Jeep.
What did you do to your JK today?
- Thread starter Lxxtsy
- Start date
ya man, I had to put something down on that cold concrete floor. It is funny, though. Sort of like the 'royal carpet' for my Jeep.
I ended up getting a foam mat I can lay on, so far seems to work well, just wish it was a little larger.
straussy
New Member
67 Designs helped me out with a iPad mount to run GPS ā¦love their stuff
Threepointsix
JK Enthusiast
Good choice.
I use a movers blanket too, so I don't crude up my garage clothes with some of the previous spillages and fluids that are on the carpet.
IndominusHuman
JK Enthusiast
Had a great trip overlanding through the nearby NF this weekend.
Most of my images are too large to upload right now so I may upload them later if enough people show interest by liking this
Most of my images are too large to upload right now so I may upload them later if enough people show interest by liking this
straussy
New Member
A few trail rides coming up and wanted a spot to mount the GoPro for some footage. Keeps it off my dash and no suction cup mounts to mess with.
77gman77
New Member
straussy
New Member
IndominusHuman
JK Enthusiast
Well, I made a thread last weekend about wheel hubs. Had no clue mine would go 7 days later.
Heard a clunk when taking off from a stop and it exploded. Threw that on after extending my diff breather tubes.
Heard a clunk when taking off from a stop and it exploded.
Threw that on after extending my diff breather tubes.
In the wifeās, replaced the left wheel speed sensors, now both rears have been replaced. Installed her GMRS Radio, antenna is temporary install till we decide what to do with the rear bumper. Depending on what we do, may mount it back there similar to mine.
Not really on JKās but picked a set of ramps when needed when I work on the Jeeps.
Not really on JKās but picked a set of ramps when needed when I work on the Jeeps.
Werenāt you just out on the trails? I assume it didnāt break out there.Well, I made a thread last weekend about wheel hubs. Had no clue mine would go 7 days later.
Heard a clunk when taking off from a stop and it exploded.
View attachment 120585
The wife got ducked the other day, she keeps it in the Jk. Said she may order some and do it.
IndominusHuman
JK Enthusiast
Yep, I was and went today.
Luckily it broke as I was pulling out of the apartments so I was able to fix it easily
Easily, really? I havenāt had to replace one. Looks complicated from the part.
ļø!
IndominusHuman
JK Enthusiast
Having a socket for the axle nut is the hardest part. Itās a 35mm so itās not something I had on hand.
Itās just as simple as taking the brake assembly off and then three bolts from the back and the axle nut.
Watched a YouTube and yes didnāt look too bad to do. I have a lot of large sockets, except mostly imperial as I used to work on semi-trailers.
Just gotta make sure to use a 12 point socket on those bolts, especially if there's any rust.
Ordered this yesterday . Iāll put it when it gets warmer. https://www.quadratec.com/products/...MI1uKN5NuP9gIVIgnnCh3W4g-REAQYAiABEgJPTPD_BwE