Danarch
JK Addict 56 From Orangevale, CA
Latest activity Postings Images About
-
-
Danarch reacted to BLACKJKU's post in the thread Help needed: Jeep suddenly overheating after changing the thermostat with
Like.
Usually you have to raise the front of the jeep up some and let it idle to get the air out. If you didn't use the proper coolant and... -
If you go with the TeraFlex kit, get their 9550 shocks to match. As tJKrider pointed out, a basic upgrade with stock and inexpensive...
-
You're welcome! Oh and welcome to the group!
-
That's the Bestop HOSS door organizer. It's missing the padded "U" brackets that go in the smaller holes on the outside lip though.
-
Danarch replied to the thread Coolant leak.I am wondering if you have checked the radiator cap? Maybe it is going bad.
-
Went up to Port Renfrew today . West Coast Vancouver Island . Explored a summit trail that went on and on and on . Switchbacks , steep ...
-
Yeah I’m in the process of buying a new catalytic converter exhaust as the one I purchased last year hangs to low . To low for spacers ...
-
Thanks to all. JScan is the route I took. Worked well getting to the ABS codes. A lot less expensive than I thought it would be.
-
Five tire rotation and balance done. Time to clean the wheels again. :) That spare was especially filthy under the cover. Oil change...
-
Turned 162,000 miles today and celebrated with a 5-tire rotation, then an oil change, front & rear diff service, along with a...
-
Some good advice already provided... Since this is your stated goal I'd look into some aftermarket flares or the Mopar High Top Flares...
-
Danarch reacted to Threepointsix's post in the thread Describe this JK in five words or less with Like.
IMO: -That is just ugly
-
Danarch reacted to WestCoastDan's post in the thread Describe this JK in five words or less with Like.
5 words or less, you say... I'm glad it's not mine. No wonder it's for sale. Why did they do that? Report stolen and burn it.
-
Danarch replied to the thread Exhaust cross member heat shield.He has the issue of the cross exhaust pipe dropping down below the cross member. Made some spacers out of some extra steel I had laying...
-
It’s an Auto . The crossover is supposed tuck right up in front of pan . Skid plate bolts on over top to protect crossover & trans ...
-
-
Loading…
-
Loading…
-
Loading…