Latest activity
-
I love winter, but am excited for spring... especially since I picked up a new Nikon Z600PF from Santa this year and I can finally put... -
CC Hawk replied to the thread Flat tow fuse pull.I have 07 jk, I start motor when getting gas or stopping for what ever,let it run few minutes. Haven't had to jump start yet. Towing...
-
FFlipx99 replied to the thread What did you do to your JK today?.Sorry, I wasn’t clear. I was referring to replacing my axles with ECGS and fully replacing the shoes and hardware with the axles out.
-
CFirst time flat-towing my new-to-me 2016 sport unlimited from Mich to Florida earlier today and yesterday. Using Ready Brute Elite...
-
CC Hawk replied to the thread 3.8 misfire.My 07 3.8l cut off after loosing power. Misfire codes, o2 sensors, can't remember anymore. After changing coil wires plugs still ran...
-
pc1p replied to the thread General Chat Thread.I love winter, but am excited for spring... especially since I picked up a new Nikon Z600PF from Santa this year and I can finally put... -
-
I noticed we didn't have a thread to just BS without a specific topic in mind so figured I would make one.
-
Cimmerian reacted to pc1p's post in the thread 2008 JKU "Argenta" Build Thread (plus a 2010 Islander side project) with
Like.
Still trying to make the OEM radiator work, but I think it's about time to throw in the towel. I cut the hose as short as I possibly... -
pc1p replied to the thread What did you do to your JK today?.I don't think the ECGS backing plates fit the JK44 housing, but perhaps they've added a new lineup. I went with these...
-
FFlipx99 replied to the thread What did you do to your JK today?.Gotcha. The backing plates are fine. I suppose it permits you to skip the step on messing with the parking shoes but I figure I’ll do...
-
I needed to measure for new shocks so I grabbed the fork lift and lifted her up a bit. And thought I'd throw a picture of my brother's... -
pc1p replied to the thread 2008 JKU "Argenta" Build Thread (plus a 2010 Islander side project).Still trying to make the OEM radiator work, but I think it's about time to throw in the towel. I cut the hose as short as I possibly...
-
-
pc1p replied to the thread What did you do to your JK today?.If your cables are in bad condition, it would make sense to do so. Backing plates (they also sell "loaded" plates) are always good to...
-
It’s a complete assembly, but is super easy to replace. I got a Mopar one as I heard the aftermarket options weren’t great. It was...
-
FFlipx99 replied to the thread What did you do to your JK today?.Thanks. I went to the normal Jeep sites and didn’t see anything. Do you think it’s helpful to also replace the cables at the same...
