Latest activity
-
Today I finally upgraded from the 255/75R17's to 285/70R17 BFG K02's! I found a set of takeoffs (all 5!) on 2022 Rubicon wheels for only... -
WestCoastDan replied to the thread What did you do to your JK today?.Today I finally upgraded from the 255/75R17's to 285/70R17 BFG K02's! I found a set of takeoffs (all 5!) on 2022 Rubicon wheels for only... -
-
BBloodblister53 replied to the thread Rough Ride/ bottom out.I installed RANCHO shocks last year!! How could these be bad already?? Gas filled ones too!! Oh what fun they are to change.
-
BBloodblister53 replied to the thread 2008 JK rough idle cannot drive stalls.My 2015 kept throwing codes and was running pretty bad. The code are the same as yours. It had a bad injector and instead of just...
-
SS832 replied to the thread Headlight adjustment.If there's a next time, perhaps. Thx.
-
Dirty Dog replied to the thread Headlight adjustment.Wouldn't it be easier to just get a new set of headlight buckets overnighted from Amazon?
-
Yes that's it. I got into it a little deeper after removing the grille and could see what was happening. The adjustment screw...
-
Your response and solution probably took longer than adjusting the headlights. Glad you got it resolved.
-
Anybodyhome replied to the thread Headlight adjustment.Your response and solution probably took longer than adjusting the headlights. Glad you got it resolved. -
Yes that's it. I got into it a little deeper after removing the grille and could see what was happening. The adjustment screw...
-
Dlcain replied to the thread What did you do to your JK today?.dropped my jeep off to my local mechanic last night. as I suspected he called me this morning and told me the trans oil cooler is... -
WestCoastDan replied to the thread 285/70/17 for stock/no lift 2014 Wrangler Rubicon 2 door?.Disregard...
-
Hence the connector at the roll bar... I saved almost 12' of wire this way. ;)
-
Dirty Dog reacted to Artisanau's post in the thread 2008 JK rough idle cannot drive stalls with
Like.
I’m just chipping in here and probably stating the obvious, but have you checked the continuity between Nō3 inj plug and the control... -
Llps83 replied to the thread O2 Sensor Heater Issue.I tried to connect the sensor directly to the wire of the ECU, same issue! It's crazy because if nothing is connected the ECU throws a...
-
