Novak Conversions Jeep Wrangler JK engine mounts

Left turn signal light works for ~5 seconds then quits

  • Thread starter Thread starter FLGeezer
  • Start date Start date
F

FLGeezer

Guest
Weird issue cropped up today on my 2009 JK. Left turn signal started flashing fast indicating a blown bulb somewhere. Rear is fine. Front off. Replaced the bulb (not LED) although the old one still looked ok. Tested it and it worked fine for about 5 or 10 seconds then quit. Rear still flashing. Tried again and before it died I Jiggled the bulb socket/harness thinking to see if it was a bad wire somewhere but it stayed on....for a few seconds.

JScan shows code B163C "front left turn lamp control circuit high". Did some Googling and searched here. Not sure on anything. Flasher relay maybe? But rear is flashing. 🤷‍♂️

Ideas? Thanks.

EDIT: Ordered a "Dorman 645-118 Three Terminal Lamp Socket" from Amazon. Will see if that does anything.
 
Last edited by a moderator:
7kuv4y.jpg
 
Three possibilities I see.

First: The old bulb was bad and the computer took a bit to learn the new circuit voltage. Essentially the code disappeared by itself. (or you cleared it)

Second: You have an exposed wire that was shorting out, it jiggled itself out of shorting out, but may come back in the future.

Third: Jeep is possessed, call an exorcist.
 
  • Like
Reactions: FLGeezer
Forth: TIPM issue maybe. My wipers are coming on by themselves every 21 seconds now. Whee.
 
BTW, I'm still seeing that code in JScan but only when I do an "Advanced Scan".

EDIT: No I'm not. Just had to figure out how to clear codes in Jscan.
 
Last edited by a moderator:
You may be right. The turn signal is fine now but I was also having a weird issue with my wipers coming on every 20 seconds (separate thread about this). Just now went out and while it was doing it I pushed up on the right wiper stalk and waited....and it's not doing it anymore. So, maybe that one is going bad too.
 
Novak Conversions Jeep Wrangler JK engine mounts
Top Bottom