Next week repelacing rotors, pads / front hubs.
The sensor wire that is attached to Moog front
bearing is 37" long.
Does anyone know if that is the same length
as OEM ?
Reading reviews on the bearing , a few complained
wire is too short ?
I can order a couple Dorman wires that are for
sure correct length. Or possibly just reuse factory
wire. But I've read they break off easy when trying
to remove from bearing .
Just trying to get a handle on things . So when
doing the project I've got everything on hand .
Thanks
The sensor wire that is attached to Moog front
bearing is 37" long.
Does anyone know if that is the same length
as OEM ?
Reading reviews on the bearing , a few complained
wire is too short ?
I can order a couple Dorman wires that are for
sure correct length. Or possibly just reuse factory
wire. But I've read they break off easy when trying
to remove from bearing .
Just trying to get a handle on things . So when
doing the project I've got everything on hand .
Thanks
Last edited: