2010 JKU will not shut off when the key is removed from the ignition
- Thread starter 2010 jk jeepwrangler
- Start date
In your comment you mention not throwing any now. What codes was it showing before ?
The Jeep electrical system can be tough to diagnose .
Reading many threads on here the last couple years it often comes down to bad ground , connection or battery terminal . Not always but often . Def check grounds and wiring connection points .
Thx, but does it shut off when you you turn the key back to "off" without having started the engine?
So we checked the with a code reader and it threw a transfer case switch.along those lines. So that's when we replaced the transfer case switch, then when he did the code reader to clear everything again, because it once again would not shut off, after all the things we have replaced, then it would not start. So that's why I threw it out there to see if anybody has any other ideas, we have done just about everything, checked every electrical connection. We know the Jeep engine inside and out. Good Lord, it just kind of stumped at this point. Everything runs all the lights. The engine reverse forward transfer case gear shift. Headlights, you know, we don't have the steering wheel connected right now, because we have all this other stuff that we've been doing, but no, everything works, we can't figure this out. So all ideas thrown at us is much appreciated
If you have the steering wheel off, now would be a good time to change the clock spring.