1. Baker14JKU

    Steering needs improvement

    I am new to Jeeps but not new to lifted vehicles. I bought my wife a 14 JKU sport that already has a Teraflex lift (it’s either a 2.5 or 3”) with adjustable short control arms front and back with fox shocks and steering stabilizer. The steering on it to me seems to be all over the road. It...
  2. Steve JK

    AEV 2.5" lift - steering questions - advice needed

    I'm about to have an AEV 2.5" lift installed on my 2009 JK 2-door (67,000 miles). I will be having the geometry correction brackets and a Fox steering stabilizer installed as well. My plan is to run 285/70r17 or 285/75r17 tires on it as well. Should I have the ball joints replaced when the...
  3. thonyG

    2015 Jeep Wrangler traction control light flashing

    i replaced the clockspring a few days ago and the traction control light turn off but then i noticed went i turn to the right or left the traction control light flashes and it feels like the abs engaged a little and the jeep lose power, it only does it when i do sharp turns, i didn’t have that...
  4. parkerdaley

    Is this used 2010 Jeep Wrangler Sahara a good purchase?

    2010 Jeep Wrangler Sahara, $19,700, ~60,000 miles, 3.8L V-6 cyl, 4WD Hi, This will be my first time purchasing a Jeep, and I'm wondering if this used car seems like a safe/reliable purchase? It has...
  5. C

    Jeep not turning over

    I have a 2008 Jeep Wrangler Sahara, purchased it used on 5/25/20. It has 124,000 miles on it, great shape. I have put 3,000 miles on it. On 9/13/20, it quit running while I was driving it. No noise or lights, just dead. The plastic part where the oil pump connected to the timing cover melted...

    Heim Joints vs 1 Ton TRE's for Steering

    Alright to begin, hey new member here 👋 and I'm glad to be a part of the forum! I need some insight on picking a good steering setup. I have a 07 JKU and having trouble deciding whether to go with heim joints or 1 ton TRE's. I daily drive my Jeep and also use it off road as much as i can. Can...
  7. Bubslipknot101

    Tie rod end vs drag link end

    So, a little bit of confusion here. I'm looking online for a replacement draglink end at the pitman arm but a lot of what I'm finding are tie rod ends. Are the ends interchangeable? Are the both the same thing?? Thanks in advance for the help!