Danarch
JK Addict 58 From Orangevale, CA
Latest activity Postings Images About
-
-
Danarch replied to the thread What did you do to your JK today?.Found out late last week the Jeep is totaled. Damage front axle, frame bent and damage to the transmission. Now waiting on the settlement. -
Glad you raised her right and she has her priorities in order.
-
Danarch replied to the thread What did you do to your JK today?.Yes she is fine. She’s more worried about the Jeep 🤣
-
Danarch replied to the thread What did you do to your JK today?.Not today, but Tuesday. Our daughter rear/ended a car that just slammed on their brakes. The cops said if it wasn’t for the dash cam...
-
-
Jeeps finally back up and running good after four months. In addition to all the other stuff listed previously, the water and oil pumps...
-
Had a few more minutes to work on the Jeep's solar today. I wired in and mounted my USB-A & USB-C charging port in the rear. I also did...
-
Danarch replied to the thread HVAC blend actuators.I am not sure about this. I think they may need to be calibrated. Are you sure you put the new one in so everything was in the same...
-
Danarch replied to the thread HVAC blend actuators.I confirmed drivers side controls the heat, passenger by door controls the recirculating air function. That basically leaves the...
-
Wanted to see if anyone could confirm which each HVAC blend door actuator does. 1. I think the drivers side sets the temperature, hot...
-
I have my 2014 listed for $15k and, while the engine is original, the entire top end has been rebuilt- cams, rockers, lifters, heads...
-
Danarch replied to the thread Removing Stuck Doors.Spray some PB Blaster and let it soak for a little bit. Move the door back and forth, that seems to help sometimes. On the jack, I...
-
Stick a block of wood on a jack, place it under the door, and jack it up until it loosens. Make sure the bolts in the door are removed...
-
It was M28. What had happened is when I was replacing the fuse last time when I went all over my TIPM, that one blew when I started my...
-
Hey guys, I found out why my Jeep wasn't starting and why I wasn't getting power to my ODB. This little bastard cost me over $1000 in...
-
Danarch replied to the thread Removing all the old coolant from 3.6.No, but I haven’t done it yet. T-state is sitting in the garage. Just been busy.
-
-
Loading…
-
Loading…
-
Loading…
