Latest activity
-
The junk Factory battery clamps are a known problem, along with dirty grounds. -
BLACKJKU replied to the thread Code P0733.The junk Factory battery clamps are a known problem, along with dirty grounds. -
ObiWan replied to the thread Code P0733.I also have the abs light on and have a new negative battery terminal but have yet to install it. Could this be the issue it’s having?
-
pc1p replied to the thread Code P0733.I think this is what they do in "limp mode". I had a similar issue, and my Jeep would also throw ABS codes and light up the Christmas... -
ObiWan replied to the thread Code P0733.Yes it is an automatic and I had the fluid serviced last year done right around 95-100k miles. The filter I have yet to service which...
-
pc1p replied to the thread Code P0733.Automatic trans I assume? Have you serviced the fluid and filter at all? The 42RLE has both input and output shaft speed sensors. I'm...
-
cpwolf replied to the thread 2008 JK 3.8 misfires, P0304 and P0300.It hadn’t sit no, it was my sons main driver. Fresh gas and maybe SeaFoam can’t hurt, agree. -
pc1p replied to the thread P0032, 2012 Wrangler.I believe these are for the 3.8L, but the 3.6L is very similar...
-
pc1p replied to the thread 2008 JK 3.8 misfires, P0304 and P0300.How many miles does the Jeep have and how long was it sitting? If it's been down for a while, gas can get wonky fairly quickly...
-
Ddison replied to the thread P0032, 2012 Wrangler.Thanks for the responses. If anyone has any specific ground locations to check, would be a great help.
-
pc1p replied to the thread P0032, 2012 Wrangler.Sounds like a ground issue or damaged harness. Someone recently just posted about some damage their harness had when the harness clip...
-
Chris replied to the thread P0032, 2012 Wrangler.The P0032 code indicates that the upstream O2 sensor is reporting a high voltage condition. Since you've already replaced the sensor and... -
pc1p reacted to tJKrider's post in the thread 2008 JKU "Argenta" Build Thread (plus a 2010 Islander side project) with
Like.
Not a Suby, but as close as I could get since I used to work for Ford: -
pc1p replied to the thread JKU Hemi Swap - Reference Guide & Swap Info.Why what? Why would I go with a HellCrate?? I thought the 707 HP made that fairly obvious :)
-
rockvegas555 replied to the thread JKU Hemi Swap - Reference Guide & Swap Info.My I ask why? I think I am about to pivot away from the 3.6 with the Magnuson supercharger. It is installed and running but I keep...