Novak Conversions Jeep Wrangler JK engine mounts

Aftermarket lights and switches

1o1Proof said:
You said post what ya got…this is what I use S-Tech 6 switch panel. I really like it, no interference with your top, everything is fused/relayed and it is so easy to add components.

I don’t have a pic of the under hood module handy, but could get it if your interest
Click to expand...

1o1Proof said:
You said post what ya got…this is what I use S-Tech 6 switch panel. I really like it, no interference with your top, everything is fused/relayed and it is so easy to add components.

I don’t have a pic of the under hood module handy, but could get it if your interested.

View attachment 128223
Click to expand...

I have a similar set up as 1o1Proof from Xprite. Super clean install and easy to add additional accessories.
 
  • Like
Reactions: 1o1Proof
Well, a long delayed update on my switch wiring. The video was for a later year model then my '08 and the panel the video used was 8 positions wide. mine is 6 wide,(edit: 5 wide) and until yesterday I was all for putting my switches there, but yesterday I found that there is printed circuit board behind all of those positions, so I am back trying to find an easy place to put them. I found Rugged Ridge makes a new panel with the proper bumps for the panel below the one in the video. oh well...
 
Last edited:
In the year that has passed, voswitch has gained some ground. I like mine. One wire through the firewall and that’s it.

1745904613486.jpeg


I know they show it mounted over the windshield, but it can be mounted anywhere.

https://m.voswitch.com/JK100-8-Swit...-Jeep-Wrangler-JK-JKU-2007-2018-p1282725.html
 
Ok, a few pictures this time. 1st, where I wanted my switches and a secondary location that won't work, and an alternative location, not ideal, but they will mount there. This is where I wanted them, but this is a printed circuit behind these locations. The alternate location will be beside the steering column, behind the key. Circles represent where they will go. I pulled the panel loose, and they will work as long as I start down about an inch or so. sorry for huge images - still learning this site.
IMG_20250429_150131479_HDR.JPG


IMG_20250429_150151275_HDR.JPG
 
  • Like
Reactions: JeepJeezy
Black Bear Jeep (Dan44) said:
Ok, a few pictures this time. 1st, where I wanted my switches and a secondary location that won't work, and an alternative location, not ideal, but they will mount there. This is where I wanted them, but this is a printed circuit behind these locations. The alternate location will be beside the steering column, behind the key. Circles represent where they will go. I pulled the panel loose, and they will work as long as I start down about an inch or so. sorry for huge images - still learning this site. View attachment 129199

View attachment 129202
Click to expand...

You could always move your Midland over to the passenger side of the center and mount the switch where your Midland was?
 
Novak Conversions Jeep Wrangler JK engine mounts
Top Bottom