Recent content by Hulkamania

So I have an update. I have just completed the power windows function. Will do a write up and a video on this soon.

I have not but will look in it. Thanks

I’m trying to locate a a certain diagram along with the fuse on my 2008 Jeep wrangler unlimited x. Attached is a he colors off the 3 wire connector that is in the dash. The colors are pink with yellow, black and white with a green stripe.any help is appreciated

Is there a way to verify what year of doors I have? I have the full doors with the newer panels (2011 and up) but the harness I have is a 14 pin square black connector

So update on the power windows. It’s looking like I’m going to build the harness for this. Will keep you updated and how everything is done and with photos

Does anyone know where I can find a pin out diagram for harness that plugs into the window and lock switches for a 2008 jku? Converting my Jeep from manual to power and that’s the only thing I’m needing to be able to complete it.

I’d check fuses and grounds. For me I had led tail lights and I swapped them back to my stocks, everything worked fine.

Haven’t had the chance yet. But if I don’t I do plan on doing some research to wire them up

Has anyone taken their jk/jku with no power windows and locks and installed and or ran wiring to have them function? I recently bought a set of full doors that has power windows and locks. I currently have the OEM half doors and do not have the lock function on them

So my cv joint finally gave up. I replaced it, but while I was removing the old one and got the new one in, I noticed the splines on the shaft were short as well couldn’t put the snap ring in. There’s no notch on the splines for where the snap ring should go. Has anyone experienced this? Is it...

Will check it and will keep you posted on what I find

I may try it on my next oil change. Im guessing it’s just a common thing with these 3.8s

I have. And still shows good. Is it a possibility that the weight of oil is too thin?

I ran what it calls for 5w-20

My 2008 jku was due for a oil change, replaced oil and re did oil pan gasket 2 days ago at 97k miles. After firing it up to get the oil flowing, it has a bad tick, do the 3.8s have noisy lifters? I attached a video for reference