Latest activity Postings Images About

• • E

    EP4 reacted to BLACKJKU's post in the thread New winch, should i spray anything on the cable? with Like.

    If you was to spray it with something the dirt would stick to the cable and could cause wear on the cable when it's spooled. You could...

    Feb 1, 2023
  • E

    EP4 posted the thread New winch, should i spray anything on the cable? in JK General Discussion.

    Just got 12k winch installed with the old school steel/wire rope. Plan to leave it uncovered because i like the look of it.. is there...

    • 

    Feb 1, 2023
  • E

    EP4 replied to the thread What could the issue be? Monitors not ready!!!.

    No CEL or codes, i have a pretty good OBDII scanner.. i actually just reset all the monitors via scanner. Hopefully it was a glitch...

    Jan 19, 2023
  • E

    EP4 reacted to BLACKJKU's post in the thread What could the issue be? Monitors not ready!!! with Like.

    If it was the O2 sensors they would be giving you a CEL. Is your CEL light working? Take your Jeep to a Auto Parts Store that does free...

    Jan 19, 2023
  • E

    EP4 replied to the thread What could the issue be? Monitors not ready!!!.

    I paid them to reflash the system as that was the known remedy for the “fuel system monitor not ready” issue. It fixed the issue, but...

    Jan 19, 2023
  • E

    EP4 reacted to BigAL07's post in the thread What could the issue be? Monitors not ready!!! with Like.

    Would not think so.BLACK JKU should chime in shortly. He is extremely good with electrical issues. Wait for him to reply before you do🍺🍺

    Jan 19, 2023
  • E

    EP4 replied to the thread What could the issue be? Monitors not ready!!!.

    Yes the dealer did a reflash/software update. That’s what they said Fuel monitor went to ready before i even got home. Evap and O2...

    Jan 19, 2023
  • E

    EP4 replied to the thread What could the issue be? Monitors not ready!!!.

    Thanks! Will this affect the PCM flash i just did?

    Jan 19, 2023
  • E

    EP4 reacted to BigAL07's post in the thread What could the issue be? Monitors not ready!!! with Like.

    I read most common problem is weak battery. If over 4 years old replace.and rerun cycle. Sensitive to glitches. Clean terminals and grounds

    Jan 19, 2023
  • E

    EP4 posted the thread What could the issue be? Monitors not ready!!! in JK General Discussion.

    Hey all, 2012 rubicon 79k miles Went to get car inspected, failed due to the notorious “fuel system not ready” all monitors green...

    Jan 19, 2023
  • E

    EP4 posted the thread What does this switch do? in JK General Discussion.

    Can anyone tell me what this pause switch is next to the seat heater? Sorry if it’s been asked before!

    • 

    Jan 8, 2023
  • E

    EP4 reacted to MacGuyver's post in the thread Does this look normal? Dual stablizer with Like.

    Given that the fairlead is painted I'm guessing this was set up for aesthetic reasons. On the bright side, we can be fairly certain...

    Jan 8, 2023
  • E

    EP4 replied to the thread Does this look normal? Dual stablizer.

    Thanks! I’ll try this!

    Jan 8, 2023
  • E

    EP4 reacted to Speartip's post in the thread Does this look normal? Dual stablizer with Like.

    The middle should def not droop like that . Dual stabilizers are more for show . A properly front end set up only needs one stabilizer...

    Jan 8, 2023
  • E

    EP4 reacted to BLACKJKU's post in the thread Does this look normal? Dual stablizer with Like.

    The clamps on the middle section that is drooping are probably loose. Just push it back up where it should be and tighten the clamps...

    Jan 8, 2023

  Show older items
• Loading…
• Loading…
• Loading…