Recent content by EP4

Just got 12k winch installed with the old school steel/wire rope. Plan to leave it uncovered because i like the look of it.. is there any spray that’s recommended to keep the wire from rusting? I’m reading some say WD40, some say chain lube… Can anyone with a wire winch rope, who leaves it...

No CEL or codes, i have a pretty good OBDII scanner.. i actually just reset all the monitors via scanner. Hopefully it was a glitch. I’m going to try and go thru all the drive cycles again, will update! If anyone had this issue before after the PCM reflash, please update! Thanks!!

I paid them to reflash the system as that was the known remedy for the “fuel system monitor not ready” issue. It fixed the issue, but now o2 is not ready. Called them and said, we have to “diagnose” and then possibly change out sensors.. Frustrating

Yes the dealer did a reflash/software update. That’s what they said Fuel monitor went to ready before i even got home. Evap and O2 were not ready, Evap became ready yesterday around 70 miles. Drove like hell today, did all the drive cycle recommendations. O2 still says not ready.

Thanks! Will this affect the PCM flash i just did?

Hey all, 2012 rubicon 79k miles Went to get car inspected, failed due to the notorious “fuel system not ready” all monitors green, except for fuel system! Upon doing research i found this is a common issue, and the fix is to get the PCM updated/reflashed. Did this, and now all monitors are...

Can anyone tell me what this pause switch is next to the seat heater? Sorry if it’s been asked before!

Thanks! I’ll try this!

Hey guys! Buying this 12 rubicon tomorrow. Is it normal for the stabilizers to droop in the middle like that? I thought they were always supposed to be straight.. new to all of this, any insight is accepted! Thanks!