Latest activity

  • F
    Just a bit of an update - still havent fixed this... Previous post i mentioned the o2 wire didnt have continuity to the PCM plug. I...
  • tJKrider
    tJKrider reacted to Cimmerian's post in the thread 2010 3.8 P0206 with Like Like.
    I can confirm Mark is the best and the fastest when it comes to that. He had my PCM tested and software updated and back to me within a...
  • W
    Wranglerfix reacted to Cimmerian's post in the thread 2010 3.8 P0206 with USA Proud USA Proud.
    I can confirm Mark is the best and the fastest when it comes to that. He had my PCM tested and software updated and back to me within a...
  • Cimmerian
    Cimmerian replied to the thread 2010 3.8 P0206.
    I can confirm Mark is the best and the fastest when it comes to that. He had my PCM tested and software updated and back to me within a...
  • Chris
    Chris replied to the thread 2010 3.8 P0206.
    Unfortunately I do not, that's just what my Google search pulled up. I would send your PCM to Mark (@Wranglerfix) to test it. He's the...
  • Mozzman19
    Madness: Doing the exact same thing over and over and expecting a change IS madness. Kidding.... we all need more levity in our lives...
  • Mozzman19
    Mozzman19 reacted to Anybodyhome's post in the thread Thermostat is baffling me with Like Like.
    Been there, done this. The best, easiest and quickest way to check your t-stat and make sure it's opening at the proper temp, or if it's...
  • Mozzman19
    Mozzman19 reacted to pc1p's post in the thread Thermostat is baffling me with Like Like.
    You should be able to go into JScan and check the monitors. On a cold engine, the ambient temp sensor and ECT sensor should show...
  • Mozzman19
    Mozzman19 reacted to pc1p's post in the thread Thermostat is baffling me with Like Like.
    Well, the likelihood of having a failed open t-stat (you can also check the one your removed too for verification) - AND having a failed...
  • W
    Wranglerfix reacted to Chris's post in the thread 2010 3.8 P0206 with Like Like.
    Given the circumstances, it is possible that the corroded injector and the broken pin could have caused enough resistance to damage the...
  • W
    Wranglerfix reacted to pc1p's post in the thread 2010 3.8 P0206 with Like Like.
    I agree with you, unless you noticed some serious corrosion, it's unlikely that just that wire from that splice is causing you grief. If...
  • W
    Wranglerfix replied to the thread 2010 3.8 P0206.
    Yes, a corroded injector or connector can cause your p0206 code. We can test and hopefully repair your pcm if you would like to send it...
  • W
    Wranglerfix reacted to dbsnyder97's post in the thread 2010 3.8 P0206 with Like Like.
    2010 Wrangler Sport 3.8 had a misfire on cylinder 6. Replaced coil, wires, and plugs and still had misfire. Figured I’d check the...
  • WSS
    Ya, hindsight says the emissions tests were not complete. No one would say it though. Not even the ref. He said I had to drive it to...
  • WSS
    interesting, typically to pass smog in SoCal with a OBDII system, you just have to have no codes and all of the smog systems checked. To...