Latest activity
-
pc1p replied to the thread BF Goodrich K03.Haha, indeed we are! :) And it's for sure an indirect tax, similar to tariffs, mandatory duty fees, etc. That said, if I'm paying more... -
I'm not going to say it's all bad as there are certainly some good aspects to it. However, at a high level it's just another attempt...
-
I don't mind discussing politics as long as it stays civil. I know its a highly emotionally charged topic, especially when it comes to...
-
MI'm looking for recommendations on a HD Rear Drive Shaft for a 2011 Jeep Wrangler 2-Door that has 37 x 13.5 x 20 inch tires with a I...
-
Cimmerian replied to the thread BF Goodrich K03.I don't mind discussing politics as long as it stays civil. I know its a highly emotionally charged topic, especially when it comes to... -
tJKrider replied to the thread BF Goodrich K03.I'm not going to say it's all bad as there are certainly some good aspects to it. However, at a high level it's just another attempt... -
I don't know as there is any legislation that could meaningfully impact the "actual" cost of healthcare, at least not one that we as a...
-
We are in the same position and are very grateful. 🙏 This issue with this "Act" is that it focuses on the insurance provider side and...
-
pc1p replied to the thread BF Goodrich K03.I don't know as there is any legislation that could meaningfully impact the "actual" cost of healthcare, at least not one that we as a...
-
-
tJKrider reacted to pc1p's post in the thread Aftermarket Backup Camera for 2015 JK (2025 version) with
Like.
Yeah that's pretty common and what I do for people that just want a simple backup camera. When I did mine, I ran a feed to the Acc wire... -
tJKrider replied to the thread BF Goodrich K03.We are in the same position and are very grateful. 🙏 This issue with this "Act" is that it focuses on the insurance provider side and...
-
They didn't even read it before they passed it. It was a rush job for a feather in Obama's nose bone. I remember my dad's insurance...
-
Lot's of questions about this in another forum so I wanted to start this Q&A thread. Here is the conversion... -
It is tight for sure. Your idea of cutting the ABS tray to lower it would work. I added a few aluminum spacers under the module to raise...
-
Mine works great. In fact it is a game changer. No issues with mine other than it being a pain to install. I think the install is where...
