Hello, I'm looking to add three sets of lights to my 2018 JKU. On the bumper I think I'm going to go with KC Hilites 6" Slimlite LED and on the A-Pillar I'm looking at KC Hilites Flex ERA 3's instead of cube lights, and some lights yet to be determined in the rear of the jeep. I've also pretty much settled on using a 6 switch S-Pod to help with the wiring. My question is this: The Flex ERA 3 lights come with a three position switch. One for amber backlighting, one for bright white light, and off. As far as I can tell the S-Pod switches are only two position. Can I wire up the amber backlighting and the white light wires to two separate S-Pod switches? Since I'm only going to be using three of them and I'll have six it makes sense to me; but I KNOW NOTHING about wiring other than my online research.
If this will not work are there other alternatives other than using the Flex ERA 3 switch separate from the S-Pod? Which I would not do btw, I would look at other lights before doing that.
I have not purchased any of the equipment yet, just doing recon before I buy. Here are a couple pics of the Flex ERA 3 switch and wires:
Thanks in advance!
If this will not work are there other alternatives other than using the Flex ERA 3 switch separate from the S-Pod? Which I would not do btw, I would look at other lights before doing that.
I have not purchased any of the equipment yet, just doing recon before I buy. Here are a couple pics of the Flex ERA 3 switch and wires:
Thanks in advance!