Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Reply to thread
Message
<blockquote data-quote="WestCoastDan" data-source="post: 464037" data-attributes="member: 23120"><p>Received the replacement ECU from WranglerFix.</p><p>It was packaged well, with appropriate documentation/links to instructions, & the return label for sending them my old unit included.</p><p></p><p>Install was as easy as described & the vehicle started on the first try.</p><p>I still had some codes and the idle seemed a bit high, so I turned it off & restarted it.</p><p></p><p>Idle returned to expected RPM range but the CEL remained on.</p><p></p><p>Turned it off and connected to JSCAN.</p><p>Ran a check where several codes remained, then cleared the codes & restarted the vehicle.</p><p></p><p>CEL is now OFF and another scan showed the only codes present are those related to the LED headlights & aftermarket radio.</p><p></p><p>Seems to run fine, so I’ll be testing it out tonight.</p><p></p><p>While I’m thrilled with the results thus far, I still don’t have any confidence in the vehicle yet.</p></blockquote><p></p>
[QUOTE="WestCoastDan, post: 464037, member: 23120"] Received the replacement ECU from WranglerFix. It was packaged well, with appropriate documentation/links to instructions, & the return label for sending them my old unit included. Install was as easy as described & the vehicle started on the first try. I still had some codes and the idle seemed a bit high, so I turned it off & restarted it. Idle returned to expected RPM range but the CEL remained on. Turned it off and connected to JSCAN. Ran a check where several codes remained, then cleared the codes & restarted the vehicle. CEL is now OFF and another scan showed the only codes present are those related to the LED headlights & aftermarket radio. Seems to run fine, so I’ll be testing it out tonight. While I’m thrilled with the results thus far, I still don’t have any confidence in the vehicle yet. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Top
Bottom