Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Reply to thread
Message
<blockquote data-quote="JeepJeezy" data-source="post: 463601" data-attributes="member: 21715"><p>Got my new rear window Molle Panels installed today. The install would of went easier without the high lift jack and air tank in the way buuuut, I wasn't removing everything. The bottom of the molle panel gets screwed on with the hardtop hardware. The top gets secured with an "L" bracket to the roll bar and a bolt to the molle panel. After you unzip the top on the roll bar padding, there's a 12mm bolt in the roll bar. You take the bolt out, slide it into the "L" bracket and screw the bolt back into the roll bar. Took about an hour.</p></blockquote><p></p>
[QUOTE="JeepJeezy, post: 463601, member: 21715"] Got my new rear window Molle Panels installed today. The install would of went easier without the high lift jack and air tank in the way buuuut, I wasn't removing everything. The bottom of the molle panel gets screwed on with the hardtop hardware. The top gets secured with an "L" bracket to the roll bar and a bolt to the molle panel. After you unzip the top on the roll bar padding, there's a 12mm bolt in the roll bar. You take the bolt out, slide it into the "L" bracket and screw the bolt back into the roll bar. Took about an hour. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Top
Bottom