Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Reply to thread
Message
<blockquote data-quote="WestCoastDan" data-source="post: 453860" data-attributes="member: 23120"><p>Time to dial-down the brightness of the LED backlights in these switches.</p><p></p><p>At the same time, I’ll try to be creative and make some type of vinyl sticker with the wife’s Cricut cutter that helps identify what each switch controls.</p><p></p><p>I’m planning to use 1/2” X 1/2” white squares w/ cutouts to identify these (4) items:</p><p>Trail camera</p><p>Side/fog lights</p><p>Center light</p><p>Reverse lights</p><p></p><p>I’ll apply the sticker over the LED to allow the identifier to be seen through the cutout when the switch is on. If I use while vinyl, they will also be visible when the switches are off.</p><p></p><p>I may just use a small arrow pointing down for the camera, (2) small arrows pointing up for the fog lights, a large arrow pointing up for the center light, and a pair pointing down on the reverse light switch; unless I can get some better ideas here.</p></blockquote><p></p>
[QUOTE="WestCoastDan, post: 453860, member: 23120"] Time to dial-down the brightness of the LED backlights in these switches. At the same time, I’ll try to be creative and make some type of vinyl sticker with the wife’s Cricut cutter that helps identify what each switch controls. I’m planning to use 1/2” X 1/2” white squares w/ cutouts to identify these (4) items: Trail camera Side/fog lights Center light Reverse lights I’ll apply the sticker over the LED to allow the identifier to be seen through the cutout when the switch is on. If I use while vinyl, they will also be visible when the switches are off. I may just use a small arrow pointing down for the camera, (2) small arrows pointing up for the fog lights, a large arrow pointing up for the center light, and a pair pointing down on the reverse light switch; unless I can get some better ideas here. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Top
Bottom