Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Reply to thread
Message
<blockquote data-quote="WestCoastDan" data-source="post: 453377" data-attributes="member: 23120"><p>Finished up MOST of the switch pod/relay panel installation today.</p><p>It took ALL day - probably because I’m really slow and meticulous.</p><p>ALL under hood/exterior connections are crimped, soldered sealed w/ marine grade heat shrink (the one with the glue-type stuff inside it).</p><p>I routed all of the wires in loom & zip tied everything to avoid any loose wires, etc.</p><p>Installed the switch pod, relocated the GPS antenna, and got the trail camera installed. Also cleaned up the wire routing and washer hoses to make access to the hole in the firewall a bit easier </p><p></p><p>Still left is to connect the trigger wire from the reverse light circuit, and then connect switched power & ground to the rear lights.</p><p></p><p>This has been a fun, but very tedious project.</p><p></p><p>[ATTACH=full]123110[/ATTACH]</p><p></p><p>[ATTACH=full]123111[/ATTACH]</p><p></p><p>[ATTACH=full]123112[/ATTACH]</p><p></p><p>[ATTACH=full]123113[/ATTACH]</p><p></p><p>[ATTACH=full]123114[/ATTACH]</p><p></p><p>[ATTACH=full]123115[/ATTACH]</p><p></p><p>[ATTACH=full]123116[/ATTACH]</p></blockquote><p></p>
[QUOTE="WestCoastDan, post: 453377, member: 23120"] Finished up MOST of the switch pod/relay panel installation today. It took ALL day - probably because I’m really slow and meticulous. ALL under hood/exterior connections are crimped, soldered sealed w/ marine grade heat shrink (the one with the glue-type stuff inside it). I routed all of the wires in loom & zip tied everything to avoid any loose wires, etc. Installed the switch pod, relocated the GPS antenna, and got the trail camera installed. Also cleaned up the wire routing and washer hoses to make access to the hole in the firewall a bit easier Still left is to connect the trigger wire from the reverse light circuit, and then connect switched power & ground to the rear lights. This has been a fun, but very tedious project. [ATTACH=full]123110[/ATTACH] [ATTACH=full]123111[/ATTACH] [ATTACH=full]123112[/ATTACH] [ATTACH=full]123113[/ATTACH] [ATTACH=full]123114[/ATTACH] [ATTACH=full]123115[/ATTACH] [ATTACH=full]123116[/ATTACH] [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Top
Bottom