Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Reply to thread
Message
<blockquote data-quote="WestCoastDan" data-source="post: 452884" data-attributes="member: 23120"><p>Modified the relay mounting plate to work with my preferred relay box. Had to bend the plate to make room for the taller box under the hood.</p><p>My bend was off by the thickness of the plate, so I had to notch out for the plug to make it sit flat.</p><p>[ATTACH=full]122917[/ATTACH] [ATTACH=full]122918[/ATTACH]</p><p>Just need to make the notch on the corner so it sits flat, trim off that extra tab, cut out the hole in the middle for the wiring, then paint.</p><p></p><p>I just ordered 60A circuit breaker, #8 power & ground cable, along with the + & - terminal blocks.</p><p>This project is moving along quicker than expected. Still slow, but there are a lot of pieces to the puzzle.</p><p>Not yet addressed is mounting & wiring for the trail cam.</p><p></p><p>All in good time.</p></blockquote><p></p>
[QUOTE="WestCoastDan, post: 452884, member: 23120"] Modified the relay mounting plate to work with my preferred relay box. Had to bend the plate to make room for the taller box under the hood. My bend was off by the thickness of the plate, so I had to notch out for the plug to make it sit flat. [ATTACH type="full" width="494px"]122917[/ATTACH] [ATTACH type="full" width="339px"]122918[/ATTACH] Just need to make the notch on the corner so it sits flat, trim off that extra tab, cut out the hole in the middle for the wiring, then paint. I just ordered 60A circuit breaker, #8 power & ground cable, along with the + & - terminal blocks. This project is moving along quicker than expected. Still slow, but there are a lot of pieces to the puzzle. Not yet addressed is mounting & wiring for the trail cam. All in good time. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Top
Bottom