Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Reply to thread
Message
<blockquote data-quote="Anybodyhome" data-source="post: 450025" data-attributes="member: 19161"><p>The adapter mounts to the soundbar, the speaker mounts to the adapter.</p><p>That being said, when you remove the original speakers, you need to keep the threaded U-clips (speed clips) if the speaker has none with them.</p><p>The SCOSCHE adapters need to be trimmed once you figure out which of the tabs/holes align with your speakers.</p><p>The speakers will ultimately not fit flush inside the soundbar because the adapter will extend it down from the soundbar.</p><p></p><p> [ATTACH=full]121848[/ATTACH]</p><p></p><p>So, the 3 tabs on the adapter will mount to these u-clips or speed clips.</p><p></p><p>Then, trim off the 4 lobes from the outer edge of the ring if you're not using those for the speaker mounting holes. There are scored lines that you can simply run a blade along and then snap them off with pliers.</p><p></p><p> [ATTACH=full]121849[/ATTACH]</p><p></p><p>Let me know what's going on and I'll try to elaborate further.</p></blockquote><p></p>
[QUOTE="Anybodyhome, post: 450025, member: 19161"] The adapter mounts to the soundbar, the speaker mounts to the adapter. That being said, when you remove the original speakers, you need to keep the threaded U-clips (speed clips) if the speaker has none with them. The SCOSCHE adapters need to be trimmed once you figure out which of the tabs/holes align with your speakers. The speakers will ultimately not fit flush inside the soundbar because the adapter will extend it down from the soundbar. [ATTACH type="full" alt="1660584370981.png"]121848[/ATTACH] So, the 3 tabs on the adapter will mount to these u-clips or speed clips. Then, trim off the 4 lobes from the outer edge of the ring if you're not using those for the speaker mounting holes. There are scored lines that you can simply run a blade along and then snap them off with pliers. [ATTACH type="full" alt="1660584537320.png"]121849[/ATTACH] Let me know what's going on and I'll try to elaborate further. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
What did you do to your JK today?
Top
Bottom