Rear turn signal goes on-and-off while I drive

[Wondreboy8]

Question for the group. I have a passenger rear turn signal that goes off and on when I drive and I get a rear turn lamp error on the dash. I have replaced the bulb, tail light harness, fuse #18 and looked for corrosion on the ground in the hood area. Is there anything else that I can do, that may be causing this problem? I have also put Dielectric Grease on most parts. Thanks in advance!

 

[BLACKJKU]

A bad wire possible the coating has worn off and going to ground when you hit a bump or ruff spot in the road.

 

[Wondreboy8]

A bad wire possible the coating has worn off and going to ground when you hit a bump or ruff spot in the road.

Do I just look for stripped wires then?

 

[BLACKJKU]

Do I just look for stripped wires then?

Probably a worn spot on the wire where it was rubbing on metal and it would have worn the coating off exposing the wire.

 

[Wondreboy8]

Probably a worn spot on the wire where it was rubbing on metal and it would have worn the coating off exposing the wire.

I’ll look around see if I have any expose areas, thx.

 

[Chris]

He beat me to it, but my advice would have been the same. Sounds like a wire / ground issue to me.

Look for corroded terminals too.

 

[Wondreboy8]

So I still havnt been able to figure out the issue, and the wires from the turn signal to the front seem in good shape what could I be missing???