Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
New here. After fluid changes and maintenance jk won’t shift to any gears
Reply to thread
Message
<blockquote data-quote="Jogyver" data-source="post: 441511" data-attributes="member: 22229"><p>The temp did spike once. Then ran 100f a bit later when starting. I did check all connections. Computer shows all good with exception of the output shaft speed sensor. Screwed around with emptying and filling the trans fluid. Still no gear engagement. Might be my luck transmission speed sensor is probably bad. Might send it off to the transmission repair shop nearby. Funny how all this happens just by doing typical maintenance .</p></blockquote><p></p>
[QUOTE="Jogyver, post: 441511, member: 22229"] The temp did spike once. Then ran 100f a bit later when starting. I did check all connections. Computer shows all good with exception of the output shaft speed sensor. Screwed around with emptying and filling the trans fluid. Still no gear engagement. Might be my luck transmission speed sensor is probably bad. Might send it off to the transmission repair shop nearby. Funny how all this happens just by doing typical maintenance . [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
New here. After fluid changes and maintenance jk won’t shift to any gears
Top
Bottom