Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
New here. After fluid changes and maintenance jk won’t shift to any gears
Reply to thread
Message
<blockquote data-quote="Jogyver" data-source="post: 441505" data-attributes="member: 22229"><p>I had a front steering u joint go bad so while fixing it I decided to do all the fluid changes . Front and rear axle , transmission and transfer case. Found some metal chunks on the rear ended drain magnet so that was something to investigate. Well it was teeth of the small spider gears in the Dana 44. Replacement gears ,axle seals and bearings installed along with two new abs sensors. Why am I including all this … it just may help figure out my issue. Trans fluid changed . Those fluid vacuums are awesome. Less mess . New gasket and a Mopar trans filter installed correctly. Fluid at the correct level. </p><p>I go to move the JK. No movement when shifting in gear. I did relearn the new abs sensors . All codes cleared. My scanner is showing no communication with the output sensor. I’m using a higher end Autel scanner computer. Has anyone had this issue and could share the possible fix?</p><p>thanks</p></blockquote><p></p>
[QUOTE="Jogyver, post: 441505, member: 22229"] I had a front steering u joint go bad so while fixing it I decided to do all the fluid changes . Front and rear axle , transmission and transfer case. Found some metal chunks on the rear ended drain magnet so that was something to investigate. Well it was teeth of the small spider gears in the Dana 44. Replacement gears ,axle seals and bearings installed along with two new abs sensors. Why am I including all this … it just may help figure out my issue. Trans fluid changed . Those fluid vacuums are awesome. Less mess . New gasket and a Mopar trans filter installed correctly. Fluid at the correct level. I go to move the JK. No movement when shifting in gear. I did relearn the new abs sensors . All codes cleared. My scanner is showing no communication with the output sensor. I’m using a higher end Autel scanner computer. Has anyone had this issue and could share the possible fix? thanks [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
New here. After fluid changes and maintenance jk won’t shift to any gears
Top
Bottom