Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
New Axle Shaft won’t go in
Reply to thread
Message
<blockquote data-quote="Austin__Peter" data-source="post: 448880" data-attributes="member: 21107"><p>So, I got a new passenger side axle shaft for my Dana 44. When I go to put it in, it goes in, and I can feel the splines matching, but there’s still a couple inches of space, and it will slip. </p><p></p><p>However, when I put my old one in, it seats all the way no problem. </p><p></p><p>They have the same spline count and everything, the only thing I could think of is the little holes at the end. The stock one has a bigger hole the the new one. Does that go into something in the driveshaft?</p><p></p><p>Is there something I have to do to the diff to seat it right?? It’s just weird because the stock one goes in just fine, but the new one won’t go in all the way.</p><p></p><p>Anyways, any help is greatly appreciated!! Please let me know!</p><p></p><p>[ATTACH=full]121531[/ATTACH]</p><p></p><p>[ATTACH=full]121532[/ATTACH]</p><p></p><p>[ATTACH=full]121533[/ATTACH]</p><p></p><p>[ATTACH=full]121534[/ATTACH]</p></blockquote><p></p>
[QUOTE="Austin__Peter, post: 448880, member: 21107"] So, I got a new passenger side axle shaft for my Dana 44. When I go to put it in, it goes in, and I can feel the splines matching, but there’s still a couple inches of space, and it will slip. However, when I put my old one in, it seats all the way no problem. They have the same spline count and everything, the only thing I could think of is the little holes at the end. The stock one has a bigger hole the the new one. Does that go into something in the driveshaft? Is there something I have to do to the diff to seat it right?? It’s just weird because the stock one goes in just fine, but the new one won’t go in all the way. Anyways, any help is greatly appreciated!! Please let me know! [ATTACH=full]121531[/ATTACH] [ATTACH=full]121532[/ATTACH] [ATTACH=full]121533[/ATTACH] [ATTACH=full]121534[/ATTACH] [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
New Axle Shaft won’t go in
Top
Bottom