Novak Conversions Jeep Wrangler JK shifters

Lightning bolt on dash limp pedal and 3 codes

P

Pirate1967

New Member
Joined
Dec 23, 2024
Messages
3
Location
Parma Ohio
New here and tried searching the threads but too much to find. I need help. Last week when I left for work the jeep started to act funny every time i pressed the gas pedal. It finally stayed on but the gas pedal limp. Could not rev engine. Codes were p0571, p0108, p2167. Well I replaced the throttle body, accelerator pedal, MAP sensor, Brake sensor and a brand new battery. The jeep starts perfectly without hesitation but still limp pedal. I did the ECU reset and the throttle and pedal relearn. Also absolutely zero codes

Yesterday I was told i should have not purchased any parts from an outside vendor other that direct OEM parts. Is there an issue with the parts that are not genuine jeep parts. Ive spent well over $600 already and no luck
 
Pirate1967 said:
New here and tried searching the threads but too much to find. I need help. Last week when I left for work the jeep started to act funny every time i pressed the gas pedal. It finally stayed on but the gas pedal limp. Could not rev engine. Codes were p0571, p0108, p2167. Well I replaced the throttle body, accelerator pedal, MAP sensor, Brake sensor and a brand new battery. The jeep starts perfectly without hesitation but still limp pedal. I did the ECU reset and the throttle and pedal relearn. Also absolutely zero codes

Yesterday I was told i should have not purchased any parts from an outside vendor other that direct OEM parts. Is there an issue with the parts that are not genuine jeep parts. Ive spent well over $600 already and no luck
Click to expand...

Some Members have bought parts that aren't OEM and had issues on electronic Parts.
 
BLACKJKU said:
Some Members have bought parts that aren't OEM and had issues on electronic Parts.
Click to expand...

That's what I figured. Tried to save a little and now its worse. I/m going to put the throttle body back and then see if the new accelerator pedal works since the other way it had not worked. (New throttle with old pedal).
 
Pirate1967 said:
That's what I figured. Tried to save a little and now its worse. I/m going to put the throttle body back and then see if the new accelerator pedal works since the other way it had not worked. (New throttle with old pedal).
Click to expand...

I replaced my TB with a OEM one and did the gas pedal reset and never had any issues after the first couple of times.
 
Novak Conversions Jeep Wrangler JK shifters
Top Bottom