Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
JK Brake Torque Specs
Reply to thread
Message
<blockquote data-quote="kk2010jk" data-source="post: 436419" data-attributes="member: 20385"><p>Working inside the wheel well on jack stands I could only muster a bit over 100 ft lbs for the fronts. Along with blue lock tight I'm ok with that amount of tightening. It sure did not take 120 ft lbs to loosen them. I could have gotten to 120 if I was working from underneath.</p></blockquote><p></p>
[QUOTE="kk2010jk, post: 436419, member: 20385"] Working inside the wheel well on jack stands I could only muster a bit over 100 ft lbs for the fronts. Along with blue lock tight I'm ok with that amount of tightening. It sure did not take 120 ft lbs to loosen them. I could have gotten to 120 if I was working from underneath. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
JK Brake Torque Specs
Top
Bottom