Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Is there a cap available for the empty dash shelf below the radio?
Reply to thread
Message
<blockquote data-quote="WestCoastDan" data-source="post: 447915" data-attributes="member: 23120"><p>Well to be honest, I went with the circled part on the photo provided... </p><p></p><p>Crank windows would make that spot a bit like the junk drawer in the kitchen, except it is too small for anything meaningful.</p><p>In that case, I'd do the same thing, but probably figure out a way to 'fill in' the opening of the shelf with something that looks kind of like this:</p><p>[ATTACH=full]121228[/ATTACH]</p><p></p><p>This could recess into the opening slightly, to avoid having any rough edges that show, and it would retain the factory clips, etc. that secure the shelf to the dash panel.</p><p>The dots are where I would use rivets, screws, etc. to secure it in the opening.</p><p></p><p>To get an exact shape, I'd probably press the factory part down over some clay, soft foam, etc. and then make a template of the shape with painter's tape.</p></blockquote><p></p>
[QUOTE="WestCoastDan, post: 447915, member: 23120"] Well to be honest, I went with the circled part on the photo provided... Crank windows would make that spot a bit like the junk drawer in the kitchen, except it is too small for anything meaningful. In that case, I'd do the same thing, but probably figure out a way to 'fill in' the opening of the shelf with something that looks kind of like this: [ATTACH type="full"]121228[/ATTACH] This could recess into the opening slightly, to avoid having any rough edges that show, and it would retain the factory clips, etc. that secure the shelf to the dash panel. The dots are where I would use rivets, screws, etc. to secure it in the opening. To get an exact shape, I'd probably press the factory part down over some clay, soft foam, etc. and then make a template of the shape with painter's tape. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Is there a cap available for the empty dash shelf below the radio?
Top
Bottom