Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Electrical issues after engine work
Reply to thread
Message
<blockquote data-quote="Garland66" data-source="post: 461132" data-attributes="member: 25578"><p>Good morning...I'll try my best to describe my issue. I did some engine work to my 2012 Wrangler. Moved the fuse box without disconnecting anything. Disconnected a lot of points from both left and right harnesses. plugged everything back correctly during assembly. Now, I am getting a "P0480-cooling fan 1 control circuit/open" code. The radiator fan is not operating. I have reset the ECM but did not resolve the issue. I did not yet re-check or reseat any connectors on that side of the harness. Additionally, the fan worked fine before this work was done.</p><p></p><p>Also (and it may be linked) the A/C compressor clutch turns off and on while it is still hot in the jeep whereas it worked fine before.</p></blockquote><p></p>
[QUOTE="Garland66, post: 461132, member: 25578"] Good morning...I'll try my best to describe my issue. I did some engine work to my 2012 Wrangler. Moved the fuse box without disconnecting anything. Disconnected a lot of points from both left and right harnesses. plugged everything back correctly during assembly. Now, I am getting a "P0480-cooling fan 1 control circuit/open" code. The radiator fan is not operating. I have reset the ECM but did not resolve the issue. I did not yet re-check or reseat any connectors on that side of the harness. Additionally, the fan worked fine before this work was done. Also (and it may be linked) the A/C compressor clutch turns off and on while it is still hot in the jeep whereas it worked fine before. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Electrical issues after engine work
Top
Bottom