Novak Conversions Jeep Wrangler JK shifters

E-brake light on after rear brakes replaced

sjack1209

sjack1209

New Member
Joined
Dec 10, 2022
Messages
3
Location
Washington state
Hey, thanks in advance for any help with this.
We replaced the rear brakes and rotors on our 2007 JKU last week and immediately the brake light on the dash came on. We tried bleeding the brakes today, including an ABS bleed and the light is still on. Fluid level is good, I'm not sure what else to look for... any suggestions
 
sjack1209 said:
No, and I've checked the ABS codes and nothing shows up. Plus the speed sensor for the rear is on the diff isn't it? I don't remember seeing any on the hub... we only did rear brakes.
Click to expand...

One on each side for the sensors. Is it the ABS light or the e-brake light?
 
  • Like
Reactions: Dirty Dog
If it was mine i'd jack up the rear axle and put trans in neutral and then turn each rear wheel and see if they turn fairly easy. If they do then the problem is with the switch and it's located at the E Brake handle. Is the handle going all the way down while holding the button.
 
Speed sensor is at the brake area. It is inserted through the parking brake backing plate. Once each side.
 
Novak Conversions Jeep Wrangler JK shifters
Top Bottom