Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Do I need to have my ABS control module flashed after replacing it?
Reply to thread
Message
<blockquote data-quote="Sahara_1" data-source="post: 430192" data-attributes="member: 19802"><p>I just replaced the ABS Control Module on my 2009 JKU. I was told that now I must go to a dealer to get the new module flashed. What does that do and is it really needed? I drove the jeep afterwards and it seems fine as far as breaking goes. If I just erase the DTC's with my scanner, is that good enough or should I still take the jeep in to get the new module flashed? Thanks again for any comments and replies.</p></blockquote><p></p>
[QUOTE="Sahara_1, post: 430192, member: 19802"] I just replaced the ABS Control Module on my 2009 JKU. I was told that now I must go to a dealer to get the new module flashed. What does that do and is it really needed? I drove the jeep afterwards and it seems fine as far as breaking goes. If I just erase the DTC's with my scanner, is that good enough or should I still take the jeep in to get the new module flashed? Thanks again for any comments and replies. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Do I need to have my ABS control module flashed after replacing it?
Top
Bottom