Ok so I have a 2013 JKU and it keeps tripping the ABS, and traction control and check engine light, when Im driving around 60-70 it trips the codes and goes into lip mode, and Jeep won't go faster than 60 MPH. I do not get a red brake light on, but have seen it pop up a few times in the past. Does this sound like the ABS control module? I replaced a rear wheel speed censor, but this is still doing it. I have a superchips so I can check the codes, right now it shows P0344 cam shaft pos sen bank 1 or sigle sens, u0121 lost comm with ABS ctrl MOD C121C torque signal denied, B162c Left low beam control circuit high, B1630 Right Low Beam Control circuit high, B1638 Right Hi Beam control Circuit High, B1634 Left Hi Beam Control Circuit High, U0121 Lost coms with ABS Ctrl Mod. So a total of 8 DTS showing. I can clear them, but they always come back after a drive on the highway.
Any one?
Any one?