Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Camshaft Position Sensor Codes
Reply to thread
Message
<blockquote data-quote="djdean7" data-source="post: 453480" data-attributes="member: 24402"><p>I had the same issue. The traction control light and the engine light were on and it would knock off my cruise control and it would bog down. We changed both sides of the camshaft position sensors and the crank shaft sensor. Still got codes. Even though we cleared the codes and tried to relearn the codes, It did not matter. We finally just took it to the Jeep dealer and the ground wire on the harness kit needed changed and that got rid of all the codes except one. They still were getting one side of the camshaft position sensor code. They investigated further and saw the end of the camshaft position sensor (has something to do with the actuator) and it was broke off, so they repaired it and now it's good to go</p></blockquote><p></p>
[QUOTE="djdean7, post: 453480, member: 24402"] I had the same issue. The traction control light and the engine light were on and it would knock off my cruise control and it would bog down. We changed both sides of the camshaft position sensors and the crank shaft sensor. Still got codes. Even though we cleared the codes and tried to relearn the codes, It did not matter. We finally just took it to the Jeep dealer and the ground wire on the harness kit needed changed and that got rid of all the codes except one. They still were getting one side of the camshaft position sensor code. They investigated further and saw the end of the camshaft position sensor (has something to do with the actuator) and it was broke off, so they repaired it and now it's good to go [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Camshaft Position Sensor Codes
Top
Bottom