Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Camshaft Position Sensor Codes
Reply to thread
Message
<blockquote data-quote="MarcSc1" data-source="post: 449697" data-attributes="member: 23524"><p>Just started doing it again!!! Took it in for tires this morning ($1600!!!)with a check engine light on because I accelerated too much(2300 rpm) this morning bringing it to the shop. So p!ssed!! So fed up!!! It has been fine for 2-3weeks!! I've been driving it around normally and accelerating normally with NO issues. So, now it looks like the issue is back. I ordered and received the new camshaft sensor connectors and didnt install them yet because I felt I didn't need to. But.... Looks like I know what I'm doing on Saturday. I had broken wire on my oil temp sensor under the lower intake accompanied by a DTC that wouldn't clear.(P0196) I repaired the broken wire and it was fine for 2-3 weeks... I thought that was the problem... But apparently it wasn't. I leave for OBX NC in 3 weeks and it's about an 8hr drive for me.... So I'm just frustrated. I'm seriously thinking about selling it. When I get the new connectors on, I'll post and let you know if it fixed it. Gimmie a few weeks of driving to really tell if it did anything or if it was all just a waste of time. Good luck Gary!!!</p></blockquote><p></p>
[QUOTE="MarcSc1, post: 449697, member: 23524"] Just started doing it again!!! Took it in for tires this morning ($1600!!!)with a check engine light on because I accelerated too much(2300 rpm) this morning bringing it to the shop. So p!ssed!! So fed up!!! It has been fine for 2-3weeks!! I've been driving it around normally and accelerating normally with NO issues. So, now it looks like the issue is back. I ordered and received the new camshaft sensor connectors and didnt install them yet because I felt I didn't need to. But.... Looks like I know what I'm doing on Saturday. I had broken wire on my oil temp sensor under the lower intake accompanied by a DTC that wouldn't clear.(P0196) I repaired the broken wire and it was fine for 2-3 weeks... I thought that was the problem... But apparently it wasn't. I leave for OBX NC in 3 weeks and it's about an 8hr drive for me.... So I'm just frustrated. I'm seriously thinking about selling it. When I get the new connectors on, I'll post and let you know if it fixed it. Gimmie a few weeks of driving to really tell if it did anything or if it was all just a waste of time. Good luck Gary!!! [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Camshaft Position Sensor Codes
Top
Bottom