Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Camshaft Position Sensor Codes
Reply to thread
Message
<blockquote data-quote="gclement" data-source="post: 447305" data-attributes="member: 23305"><p>Just wondering if anyone has come across this before. My JK 2013 is throwing cam shaft sensor codes, typically P0344, P0340, P365, P345 and P390 both as intermittent and permanent. The odd thing is that if the vehicle is left to cool down the codes clear and the Jeep can be started and it runs okay without any issues, until it reaches operating temperature and the codes pop up again, limiting the revs to about 3000. Have tried changing the sensors which made no difference, currently changing the connector's and chasing the wires back to the PCU. Has anyone else experienced this and if so what was the case of action taken to correct. Thanking you in advance.</p></blockquote><p></p>
[QUOTE="gclement, post: 447305, member: 23305"] Just wondering if anyone has come across this before. My JK 2013 is throwing cam shaft sensor codes, typically P0344, P0340, P365, P345 and P390 both as intermittent and permanent. The odd thing is that if the vehicle is left to cool down the codes clear and the Jeep can be started and it runs okay without any issues, until it reaches operating temperature and the codes pop up again, limiting the revs to about 3000. Have tried changing the sensors which made no difference, currently changing the connector's and chasing the wires back to the PCU. Has anyone else experienced this and if so what was the case of action taken to correct. Thanking you in advance. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Camshaft Position Sensor Codes
Top
Bottom