Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
C2101 & C2103 codes
Reply to thread
Message
<blockquote data-quote="Iflyu2" data-source="post: 444729" data-attributes="member: 22850"><p>Yep, I had all the same issues and my obd read a bad brake switch. Changes it out in about 15 minutes and so far no more problems. One quick thing though, after you changed the switch make sure you pull back on the brake (toward you) before you run a new set of diagnostics. I didn’t and had a whole slew of errors I won’t go into and my Jeep wouldn’t move. Since you have to push a little forward on the brake pedal to install the new switch it holds the brake on and thus the errors and not moving.</p></blockquote><p></p>
[QUOTE="Iflyu2, post: 444729, member: 22850"] Yep, I had all the same issues and my obd read a bad brake switch. Changes it out in about 15 minutes and so far no more problems. One quick thing though, after you changed the switch make sure you pull back on the brake (toward you) before you run a new set of diagnostics. I didn’t and had a whole slew of errors I won’t go into and my Jeep wouldn’t move. Since you have to push a little forward on the brake pedal to install the new switch it holds the brake on and thus the errors and not moving. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
C2101 & C2103 codes
Top
Bottom