Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
C2101 & C2103 codes
Reply to thread
Message
<blockquote data-quote="KCsJKU" data-source="post: 426166" data-attributes="member: 17751"><p>Any help would be great. I have a 2014 JKU and was driving this evening when all the sudden, I had an audible tone (like low fuel), my speedo went to 0 and slowly went back to the speed I was going and my traction control light came on. About 5 minutes later, it did it again. I noticed just a slight loss of power for a second when this happened. It happened a3rd time and now the battery light was on too. When I got home (this all happened within a 10-12 minute time frame), I began to back into my driveway and it dies. I try to crank it again and nothing. Had to take it out of gear and roll it down the street. A few minutes later, I was able to crank it and I read the codes. It showed C2101 and C2103 for battery and system high voltage. My traction control light is off now and no codes for it. Anyone have similar issues?</p></blockquote><p></p>
[QUOTE="KCsJKU, post: 426166, member: 17751"] Any help would be great. I have a 2014 JKU and was driving this evening when all the sudden, I had an audible tone (like low fuel), my speedo went to 0 and slowly went back to the speed I was going and my traction control light came on. About 5 minutes later, it did it again. I noticed just a slight loss of power for a second when this happened. It happened a3rd time and now the battery light was on too. When I got home (this all happened within a 10-12 minute time frame), I began to back into my driveway and it dies. I try to crank it again and nothing. Had to take it out of gear and roll it down the street. A few minutes later, I was able to crank it and I read the codes. It showed C2101 and C2103 for battery and system high voltage. My traction control light is off now and no codes for it. Anyone have similar issues? [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
C2101 & C2103 codes
Top
Bottom