Broken alternator plug retaining clip

[danmpls]

Hey all,

On my 2017 JK there's a 2 pin connector for the alternator, and I managed to snap off the clip on the alternator itself. I've found plenty of advice on replacing the 2 pin pigtail, but nothing on what to do with this problem short of replacing the alternator.

Stock photo below. The small retaining clip between the two fins is gone.

 

[pc1p]

Only potential solutions I can think of are:
1) using some tape or zip ties to secure it to the alternator housing or
2) drill a small hole where the tab used to be, then use a small, watch-style screw to keep it in place.

 

[danmpls]

Only potential solutions I can think of are:
1) using some tape or zip ties to secure it to the alternator housing or
2) drill a small hole where the tab used to be, then use a small, watch-style screw to keep it in place.

Yeah I've got tape on there for now, but switching to zip ties and clamping it down is likely the move. Thanks!

 

[pc1p]

Another alternative would be to cut some slits in the wire-side connector and then use a small hose clamp on that to "squeeze" the wire-side connector onto the alternator. This of course would be modifying a part that ISN'T broken, but would likely solve the issue as well.

Of course there's the obvious, just buying a new alternator I see lots of Jeep part outs near me. I'd imagine if you had similar in your area you could pick up a new one for ~$40 or so.