Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Blinker Issue
Reply to thread
Message
<blockquote data-quote="cpwolf" data-source="post: 429175" data-attributes="member: 19674"><p>I believe on the JK the fast blink is to notify a bulb is out. A bad ground like you said, can do that same. Just curious, when you say your RF blinker was blinking fast, was your right rear not blinking the same speed? Been a while since I changed one, but don't they all go one side same speed? I ask, because have you checked your rear bulb? Sometimes it gets unseated, some corrosion etc, or the filament is cracked not fully out. </p><p></p><p>Trailer is weird, maybe it is a bulb, but it's reading a completed circuit with the trailer connected for some reason? Maybe you can run a jumper from the side blinker and front blinker if you have that for the grounds, I seem to remember someone mentioning that, but I can't remember the detail.</p></blockquote><p></p>
[QUOTE="cpwolf, post: 429175, member: 19674"] I believe on the JK the fast blink is to notify a bulb is out. A bad ground like you said, can do that same. Just curious, when you say your RF blinker was blinking fast, was your right rear not blinking the same speed? Been a while since I changed one, but don't they all go one side same speed? I ask, because have you checked your rear bulb? Sometimes it gets unseated, some corrosion etc, or the filament is cracked not fully out. Trailer is weird, maybe it is a bulb, but it's reading a completed circuit with the trailer connected for some reason? Maybe you can run a jumper from the side blinker and front blinker if you have that for the grounds, I seem to remember someone mentioning that, but I can't remember the detail. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Blinker Issue
Top
Bottom