Can’t figure this out. Replaced plugs wires and coil pack only misfires on 1,3 and sometimes 5. O2 codes also. Replaced sensors. Any help is greatly appreciated
3.8 misfire
- Thread starter ktm909
- Start date
Did you use OEM parts, sometimes that's the issue when your replacing parts and still the same problem.
Dirty broken grounds is another common problem, along with the junk Factory battery clamps.
How many miles on the Engine?
If I remember right 1,3, and 5 are on the same side of the engine so maybe the harness going to those cylinders for the injectors.
Dirty broken grounds is another common problem, along with the junk Factory battery clamps.
How many miles on the Engine?
If I remember right 1,3, and 5 are on the same side of the engine so maybe the harness going to those cylinders for the injectors.
Champion plugs Omni spark wires. Orielly lifetime coil pack 112000 miles. Bosch o2 sensors. Going to check grounds have not messed with injectors
I doubt if all 3 injectors would go bad like that, i'm saying could be the wiring harness that comes from the ECM. There should be a ground I believe in that harness for the injectors.
Any ideas or places to start to check that. Code or misfires is po300 if that helps
Have you looked at any of these fixes?
https://www.google.com/search?q=jee...gH_wLCBwUyLTIuMcgHFYAIAA&sclient=gws-wiz-serp
I have read a lot that Bosch in particular can trip codes in these vehicles. The OEM are NGK.
Found the braided ground totally rotted of down at the block. Now I need to find the other end and reconnect. Hopefully this solves the problems