Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
2013 Jeep Wrangler 3.6L Starting Issues After Doing Lifters and Timing Chain
Reply to thread
Message
<blockquote data-quote="cmw" data-source="post: 465549" data-attributes="member: 26375"><p>Hi new guy here. I am going thru a similar issue with my 2014. new timing chain, rocker, lifters, oil cooler, oil pump. cam sensors, cam phaser postion sensors. water pump, thermostat, belt tensioner, and I have an aluminum lower intake on way from amazon.My plastic lower intake is shot. . Did you soak the lifters over night? Make sure your vaccum lines ARE connected. Did you make sure the throttle body wiring is connected? Anyway I have the Autel MX900 bi direction scanner. Do several phaser cleanings, both intake and exhaust. reset the ECM and do a cam relearn. Reset the RPM's to 900 that should get you running.Somuch for hsrbor freight torque wrenches. Note: The Engine Camshaft Cam Phaser Actuator Position Sensor pin should move freely, There like 16 bucks each, I just repalced all 4 cause I plan on getting anouther 100K miles out of this block. Alittle late but going to do a leak down test this coming friday(next day I have off) . I'll keep you updated and please do same.</p></blockquote><p></p>
[QUOTE="cmw, post: 465549, member: 26375"] Hi new guy here. I am going thru a similar issue with my 2014. new timing chain, rocker, lifters, oil cooler, oil pump. cam sensors, cam phaser postion sensors. water pump, thermostat, belt tensioner, and I have an aluminum lower intake on way from amazon.My plastic lower intake is shot. . Did you soak the lifters over night? Make sure your vaccum lines ARE connected. Did you make sure the throttle body wiring is connected? Anyway I have the Autel MX900 bi direction scanner. Do several phaser cleanings, both intake and exhaust. reset the ECM and do a cam relearn. Reset the RPM's to 900 that should get you running.Somuch for hsrbor freight torque wrenches. Note: The Engine Camshaft Cam Phaser Actuator Position Sensor pin should move freely, There like 16 bucks each, I just repalced all 4 cause I plan on getting anouther 100K miles out of this block. Alittle late but going to do a leak down test this coming friday(next day I have off) . I'll keep you updated and please do same. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
2013 Jeep Wrangler 3.6L Starting Issues After Doing Lifters and Timing Chain
Top
Bottom