Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
2.5" lift, 3.0 caster, do I need lower control arms
Reply to thread
Message
<blockquote data-quote="mrjp" data-source="post: 450596" data-attributes="member: 19765"><p>If I remember the bottom holds the axle centered correctly (front to rear) and the top is used to adjust the castor. [USER=18221]@BLACKJKU[/USER] or someone else might be able to confirm that. If so your top control arms are a little too long. I would shorten both top arms by an inch and test drive and if good or better get another alignment.</p></blockquote><p></p>
[QUOTE="mrjp, post: 450596, member: 19765"] If I remember the bottom holds the axle centered correctly (front to rear) and the top is used to adjust the castor. [USER=18221]@BLACKJKU[/USER] or someone else might be able to confirm that. If so your top control arms are a little too long. I would shorten both top arms by an inch and test drive and if good or better get another alignment. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
2.5" lift, 3.0 caster, do I need lower control arms
Top
Bottom