Search results

Naw he does our weed eating for us. So its worth that to not have to do that job. But he sure has trouble getting into this jku. 6'6" and 280lbs he's not a small boy.

Update to my issue. Sent my fuse box off to get rebuilt. It was late leaving ups, even though I got it there in plenty of time. Then it sate in Jacksonville Fl for a week. As the Hurricane that hit Fl and Nc and Tn did it number. Then it was a week later to get it back from the place in Fl. Put...

Thanks guys, I checked all grounds today. Son in law works on robots, he even went over the grounds. All grounds are showing low resistance. From 2 to 0, also no power at all at the rear. I did get a reply back from a guy that rebuilds the TIPM today. Thank you for reaching out! Yes, the issues...

Anyone know where Ground G300 is at? Shows up on the right side of that diagram. Location Body Floor between front seats. But have not found it .

Guys the trailer wiring has been there for a year. But I did remove it just in case. Also I unplug the trailer plug before backing in the water. But new wiring and lights on the boat trailer a few weeks ago. Blame stray dog eat the plug off the boat. Also pulled the boat today with my Ram 3500...

All 4 I know of up front. Both on the drivers and Pass side foot well. Both under the seats. 2 on the engine block its self.

Yes followed it all the way up front. Can't find any spot that looks eaten on. Still thinking ground, but for the life of me can't find that ground. Had to be one for just though lights. Also southern jeep, no rust. So far have not found a wire growing green stuff yet.

I have heard that light switch can cause part of this issue. But being the front works, but not the back? Also third brake light should not be effected by the light switch?

Just went out reset the Jscan settings. Still no rear lights. Removed batter cables and tied them together. Try that again.

Center or third brake lights not working. Jscan did show I think it was current high on Right tail light. That was about the only code it showed for any of this. Might see if I can find the reset button and try it. Trailer plug has been installed for a year. Happened before dunking the boat...

Trailer plugs a 4 way. Nothing on it dead also. Used the kit to add the trailer plug that plugs into the drivers side tail light plug.

Yes horn works. Hazard lights in front only. Back there's nothing.

Yes sorry guess I forgot to add that.

2009 Jeep Wrangler JKU Pulling the boat Friday. Noticed I had a air bag light, Seat belt Light on. Also no interior light, no tail lights, no rear turn lights, no brake lights. Even the Third brake light is not working? What I have done so far. Checked every ground I could find. Right front...