Search results

🤣🤣🤣🤣🤣🤣

No, oil pressure fine...Just trying to prevent a spun bearing...

Hi guys just a question....Has anybody put main and rod bearings in their 3.8 engine ???? What I would like to know is the bearings all standard with no odd sizes to make them work...I've got 175,000 on my engine and was going to check them and probably replace them...

Yes, It shifts fine after warming up..

My Trans shifts are hard in cold weather with this ???.

Hey guys, wondering what lube would shift good in cold weather for my 6 speed...I changed it this summer with penszoil sycromesh...It works good when it's warm outside but not so much in the cold weather, until it warms up...

Thanks for the info...

I've got a 2011 wrangler sport unlimited jku with 3.8 and 6 speed..I believe I've got a dana 44 for a rear diff, is there any way to know if it's a open diff or not without pulling the cover ??? Thanks for reading !!!

Finished up front axle seals...New seals,4 ball joints , R/L steering knuckles, R/L front bearing hubs and new axle u joints...75/90 full synthetic for refill.....500.00 in parts...😪😪🤣🤣

Thanks, for everyone's imput !!!!

Just ordered a set of Rough country heavy duties....129.95 ...Hopefully these will be ok...The only off roading I do is during deer season...

Any suggestions on a brand of ball joints that will last ????

I know , this job has snowballed into a lot of new parts just to replace axle seals....The last thing are the ball joints ....

170,000

BTW all this started with replacing front axle seals, which is done waiting on parts..

Hi guys, I'm in a project replacing front steering knuckles ( extremely rusted)...Also will be replacing u-joints wheel bearing hubs and bolts....The ball joints seem to be original 2011but have no play in them, the uppers will rotate but no movement in them....Should I replace or leave them in ????

Engine running well, the only noise I hear is a small start up noise that goes away in a second after the first start of the day.....I'll just change the gaskets and leave it alone. THANKS...

Hi guys, I have a high mileage (169,00) 2011 wrangler Jk with the 3.8 engine..I'm going to replace both oil pan gaskets due to a upper oil pan leak.. My question is, would you go ahead and change the main and rod bearings also ????