Search results
-
B
Camshaft Sensor Wiring Pin 2 Has No Voltage (P0369, P0365 etc)
A Chrysler dealership determined there was a short in the wiring and installed a wire overlay. For them, I assume that is the quicker solution than isolating the bad wiring. I have not gone back and checked the voltage on pin 2. Since getting it back from the shop it ran fine for several days...- Bberryhill
- Post #3
- Forum: JK General Discussion
-
B
Camshaft Sensor Wiring Pin 2 Has No Voltage (P0369, P0365 etc)
2014 Jeep Wrangler (JKU) Rubicon. Problem started with the P0365 and P0369 codes coming up. Jeep continued to run fine until it didn’t. Now stuck in the ”limp” mode. I was going to replace the camshaft sensors but took a few minutes to test the wiring before replacing the sensors. On both...- Bberryhill
- Thread
- Replies: 3
- Forum: JK General Discussion