Search results

  1. mjonesjr84

    What did you do to your JK today?

    I swapped out my OEM clock spring because I was getting codes P0581 Speed Control Switch 1 Circuit High, P0579 Speed Control Switch 1 Performance, & P0591 Speed Control Switch 2 Performance. The cruise control would go off after a short period of time or when I turned the steering wheel. So far...
  2. mjonesjr84

    What did you do to your JK today?

    Installed the Diabolical Slipstream rear enclosure and fire extinguisher today. This rear enclosure is nice. Only compliant I have is the instructions say there is a pin on the upper back area, but it didn't come with them. I'll call them Monday. It is nice having the full rear coverage vs the...
  3. mjonesjr84

    What did you do to your JK today?

    This week, removed the upper intake again and took the driver side injector/coil wiring harness out. There were several wire cuts. After fixing, I've not gotten a single code that I mentioned above. Today I installed the Energy Suspension polyurethane spare tire bumper extension to keep the...
  4. mjonesjr84

    2012 3.6 Throwing P0206

    I found several wires that had the jacket chaffed off on the driver side injector harness. I pulled it out and fixed them all. So far, fingers crossed, it has fixed the issue.
  5. mjonesjr84

    2012 O2 Sensor Reading

    Disregard this. I started tracing wires and found all 4 wires for the B2S1 O2 sensor were cut right were they go into the main harness. Cut the wires out of the harness and connected them back together and all is well.
  6. mjonesjr84

    2012 O2 Sensor Reading

    My 2012 was showing 1.3v for the B2S1 O2 sensor. I put in a new sensor (Walker) and it still reads the same. The B2S2, B1S1, & B1S2 sensors all ready within spec (.1-.9v). I have checked out the wiring and do not see anything. Anyone ever have this issue or know what I could look for?
  7. mjonesjr84

    What did you do to your JK today?

    That's on my list to do.
  8. mjonesjr84

    What did you do to your JK today?

    Earlier this week I put a set of 33's on 17x9 wheels and an Auxbeam switch panel and hooked up my blue lights for the VFD. This will give me a spot for the seat heaters and front lights when I get them installed. Luckily I didn't sell the 33's when I went to 37's on my TJ. Changed the oil...
  9. mjonesjr84

    How to Replace the Clockspring on a Jeep Wrangler JK

    FYI, if you have a 2011-2018 JK, your clock spring is under a 15-year unlimited mile warranty recall. IF it has one of the codes listed in the bulletin, Jeep will replace it for free. https://static.nhtsa.gov/odi/tsbs/2017/MC-10217579-9999.pdf
  10. mjonesjr84

    What did you do to your JK today?

    Installed the Kentrol hood latches and the Wolfbox G900PRO mirror. I love these latches on my TJ. Hopefully they do the same and eliminate hood flutter and worry about the rubber stock latch.
  11. mjonesjr84

    2012 3.6 Throwing P0206

    Thanks Chris. I'm planning on swapping the oil cooler for an upgraded Dorman and while I was in there I was going to change plugs and coils. I'll check the wiring tonight. Should see a difference by unplugging the injector, if I can get to it without taking the upper intake off.
  12. mjonesjr84

    2012 3.6 Throwing P0206

    I just picked up a 2012 with the 3.6 in it. On the drive home, it set a check engine light that showed a P0206. The engine doesn't run bad or rough at all. I've searched a little on the interwebs but not found anyone experiencing the same with an engine that still runs good. Anyone have any...