pc1p's latest activity
-
pc1p replied to the thread Junkyard 1-ton swap!.Any updates on this build? You get to wheel it at all over the summer? -
Did a quick trip up to Marble CO and did a couple miles on Lead King Basin and Crystal Mill Loop. The road was washed out and impassible...
-
Thank very much, I appreciate your help and advice.
-
When I was a kid in ‘80’s, my family went camping and traipsing through the Rockies in a 1980 F-150. In 2019, I wanted to get a vehicle...
-
pc1p reacted to TRevs's post in the thread In the market for a JK; how to know if it's lifted? with
Like.
We bought that Rubi; i started a build thread here -
pc1p replied to the thread Rust in rear wheel well.I would leave as much structure in place as you can as this will help give the foam something to "bite" into. Encapsulator would be...
-
pc1p replied to the thread Stock Spare Tire Carrier.My JKU had a 285/75 on the back without issue and it's now on my daughter's Jeep. There aren't any vibrations, because I made sure to...
-
This has been my strategy as well with a decent rattle can paint. It works remarkably well, imo, and doesn't come with the issues of...
-
pc1p replied to the thread Rust in rear wheel well.You will need to mechanically remove the flaking rust. The easiest way to do it is to use a needle scaler and go to town. I have this...
-
pc1p replied to the thread Rust in rear wheel well.I have to disagree with this. This is an Old Wives Tale from the guys that sell Fluid Film and other oil-based products lol... seriously...
-
pc1p replied to the thread Rust in rear wheel well.If you use a closed-cell foam and coat the metal below, it would hold any moisture. Closed-cell foam is what they use to make boats out...
-
pc1p replied to the thread Rust in rear wheel well.For an encapsulator, paint, and similar stuff, I like Eastwood products. I'm currently working on my JKU and am cleaning and sealing...
-
pc1p replied to the thread Rust in rear wheel well.I'm afraid that @JeepJeezy is likely right - this probably isn't the only spot you're having issues with. I would check the torque boxes...
-
pc1p replied to the thread 2008 JKU "Argenta" Build Thread (plus an Islander side project).I've got a work trip this week, but was able to swap out the setup bearings for the final bearings. No change in pattern and no change...
-
-
pc1p replied to the thread 2008 JKU "Argenta" Build Thread (plus an Islander side project).I finally remembered to pick up a new 3-jaw puller (for the yoke!), and got started setting up for pattern on my the Islander's D44. I...
-
