Recent content by Mz B Haven

Here is a couple of pictures of my swap. One is of the initial test fitting and the other is the completed project.

The Jeep (Mz B Haven) is a 2015. The Terminator ECU has a tach wire that I am not using because I used a Holley Pro Dash that plugs directly into the ECU harness. Can I connect the tach wire to the Jeep PCM for a signal to tell it to stop the starter? If so, where do I connect it?

I have recently completed my LS swap. I am using a Holley Terminator X Max to run the engine and trans but kept the JKU PCM to run everything else. However, upon starting it the starter stays engaged after the engine is running due to the PCM not seeing an rpm signal from the engine. Is there...